How green are your green electronics?
5volt writes –
Are electronic devices really in a very low power mode when on stand-by? Also, how much energy am I wasting for powering devices when not in use?
I wanted to check it out and decided to build a device capable to detect stand-by mode of my electronic devices and start metering energy used. All this had to be done automatically without my intervention. Metering would start upon entering stand-by and stopped upon exiting.
To do so I needed an energy meter and a current gauge to monitor the current of mains supplied devices and start/stop metering.
For the meter I first looked for silicon, of course. Energy metering is a hot issue with a lot of chip makers and many of them supply cheap solutions.
The project was proceeding when recently I was lucky enough to find two electromechanical meters at a local special trash collecting center (electrical, white goods, furniture).
Actually there should be a plenty of these scrap meters available here as the local electric company is replacing these meters with remotely controlled electronic meters.
I took them along with two VCRs and a printer. The first meter I opened and dismantled to satisfy my inner primary need. The second meter I decided to use in place of the silicon-based one; also, the ready made electromechanical meter solved the calibration issue.
How green is my green electronics – Link.
More: continued here